Knowledge base

Highbeam X for Citroën ë-Berlingo 2025+

Highbeam X for Citroën ë-Berlingo 2025+ – Auxiliary Lights on Electric Van

The Citroën ë-Berlingo 2025+ is an electric van with a fully digital LED lighting system. Highbeam X connects at OBD2 pin 6 (CAN-H) and pin 14 (CAN-L) and outputs a 12-volt relay trigger for auxiliary lights without affecting EV systems.

EV CAN Bus on Citroën ë-Berlingo 2025+

The ë-Berlingo uses CAN bus for all lighting control. Highbeam X reads the high beam signal at OBD2 pin 6/14 in read-only mode.

Installation

Connect at OBD2 pin 6 (CAN-H) and pin 14 (CAN-L). Alternative: BodyCAN. No coding required.

Auxiliary Light Compatibility

All 12-volt lights supported. Minimal power draw — safe for EV use.

Does Highbeam X work on Citroën ë-Berlingo 2025+?

Yes. Highbeam X is compatible with the ë-Jumpy EV platform and connects at OBD2 pin 6/14.

Where does Highbeam X connect?

OBD2 pin 6 (CAN-H) and pin 14 (CAN-L) under the dashboard. Alternative: BodyCAN connector.

Is coding required?

No. Highbeam X is read-only and plug-and-play with no coding.

Will Highbeam X affect my warranty?

No. Highbeam X is a read-only device and does not modify or communicate with any vehicle systems. It is completely non-invasive and reversible.

Does it affect EV range?

No. Highbeam X has minimal standby consumption. Only 27 MA